![]() Ensure that this track is sent to your speaker output and NOT to the output that's connected to your amp via the re-amp box to avoid a feedback loop. Position a microphone to record the amplifier and connect this to an available input on your interface (screenshots use input 1 as the example).įinally, in the DAW, create a new track with the correct input assigned. In Focusrite Control, this setting is defined on the Device Settings page.Ĭonnect this output to your re-amp box to take the signal from 'balanced line' to 'unbalanced instrument' level (the level your amplifier is designed for), then connect the output of the re-amp box to your guitar amplifier. In Scarlett/Saffire Mix Control this is accomplished by holding shift & clicking the box on the right side corresponding to that output to turn it grey. If you're using an interface that utilises Scarlett Mix Control, Saffire Mix Control or Focusrite Control, assign 'DAW 3' to the physical output you will be using.Įnsure that you don't have any Direct Monitoring/Low Latency Monitoring enabled and that this output is set to full-scale (not controlled by the software volume dial). In your DAW, set the output of the track you have your dry signal recorded to an output NOT being used by your speakers (e.g. Note: It's not possible to monitor while re-amping with the Solo or 2i2 since the headphone output mirrors the line outputs, so you would just hear the dry signal through one side of the headphones and nothing else. If you are using a Scarlett Solo/iTrack Solo then you will need to disconnect your speakers and use an RCA to 1/4 inch jack cable in order to connect to the re-amp box. If you have a Scarlett Solo, 2i2, 18i8 (1st and 2nd Gen) or an iTrack Solo you will need to disconnect your speakers while re-amping. This means that you won't need to sacrifice having speakers connected for monitoring while performing the steps below. Ideally, this method works best when using an interface with more than 2 line outputs. Alternatively, you can use a DI box in conjunction with a mic or line input to record the dry signal. All current Focusrite interfaces have at least one 'instrument' input so that you can connect a guitar/bass directly and record the dry signal into your DAW. Re-amping is the process of taking a dry, direct recorded guitar signal and passing this through a guitar amplifier. ![]() This applies to the Scarlett, Saffire, Clarett, Forte and Red interfaces
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |